Teach you how to use an insulin injection pen China

Blood sugar raised?

Don't be afraid! Taking medicine on time and injecting insulin on demand is not a problem to control blood sugar!

How to use insulin pen?

look here look here

No.1 Wash hands before injection

No.2 Check insulin type and dosage

No.3 Install the refill

Before installation, carefully check whether the refill is in good condition and whether there are cracks; whether the color and character of the liquid medicine in the refill are abnormal, whether there is floc or crystal precipitation; whether the refill has expired. If you are using insulin cloud form (insulin suspension), it should be mixed well before each injection - roll the pen back and forth 10 times in your hand, and then shake it up and down 10 times to ensure that the insulin cartridge has become Uniform white haze. If the refill is already installed, mix in the pen.

After confirming that it is correct, twist open the refill holder, put in the refill, and use 75% alcohol to sterilize the rubber film at the front of the refill.

No.4 Install the needle

Install the needle: Take out the needle, open the package, and tighten the needle clockwise to complete the installation. Remove the protective needle cap when injecting.

Exhaust: For the newly replaced refill, since the drive rod is not in close contact with the tail end of the refill, if the injection is performed without exhaust, the injected dose will be reduced by 4 to 6 units. Hold the pen vertically so that the air bubbles in the refill gather at the top, turn the dose adjustment knob to "2 units", and then press the injection button to reset it to zero. If a drop of insulin overflows from the needle, it means the drive rod It has been in full contact with the refill and the air bubbles in the refill have been completely exhausted. If no liquid comes out, repeat this until one drop of insulin is expelled.

NOTE: Do this every time you install a new refill and needle.

No.5 Check the injection site and disinfection

No.6 Choose the appropriate injection method

If the injected insulin is a suspension (such as intermediate-acting insulin or premixed insulin), the insulin pen should be turned upside down about 10 times until the liquid becomes a uniform white suspension to prevent uneven concentration of the liquid. Poor blood sugar control. Rapid-acting insulin, short-acting insulin, and insulin glargine are clear solutions that can be injected directly.

No.7 Injection

Pinch the skin at the injection site with the left hand, hold the insulin pen with the right hand, insert the needle quickly, press the injection button with the right thumb to inject the liquid slowly and evenly, after the injection is completed, the needle stays under the skin for 10 seconds, and then quickly pull out the needle along the needle insertion direction , press the eye of the needle with a dry cotton swab for 30 seconds. Cap the needle and end the injection.

No.8 Discard the needle

Before throwing away insulin injection needles, cap the needles, or put them in a hard plastic or metal container with a lid marked "non-recyclable" to prevent sharp objects from being mixed into household waste and increase the risk of puncture and infection by others.

It's that simple!